6mm Diamond Holesaws Tile Drill Bits Tool Core Drill Hole Cutter for Glass Slate Porcelain Marble Set of 10pcs
(as of Feb 05,2023 11:30:46 UTC – Details)
-Need Cooling and lubrication.
-Diamond hole saw tile ceramic glass porcelain marble drill.
-Always use lubrication (water), if not the diamond core will over heat.
-Use for conventional power drills on the low speed setting with the hammer action disabled.
-These are auiable for drilling ceramic tiles, glass, marble, slate and porcelain tiles up to hardness grade 5.
-If you’re drilling on a vertical surface try a hand spray water bottle, or sponge soaked in water and held underneath, but in contact with the drill bit.
-Keep the bit as wet as possible during operation, if the bit dries out during use it will overheat and immediately blunt.
-How to use:
-Clamped firmly to a bench to allow for slow controlled drilling.
If drilling in situ or at an awkward angle, can try following method:
Make a template from a piece of timber or waste material, locate this over the area where you want to drill your hole and use it as a “guide” to start the hole.
Once you’ve got into the surface by 1mm to 2mm you can remove the guide and continue to drill in a controlled manner.
-Start your hole diagonally, make a round trace and then hold drill straight.
10 x 6mm (1/4″) Diamond Holesaw
MPN:[AUTO FILL EAN]
Mainly used for drilling glass porcelain tile, ceramic tile, marble, granite ,rebar concrete and other hard material.
Note: Keep the bit as wet as possible during operation, dry drilling will cause bits overheat and become blunt.
Hole size: 6mm