ZFYQ Hole Saw Drill Bits Set for Glass, Ceramic, Porcelain, Tile, Marble, Ø6mm-50mm, Set of 15
(as of Feb 06,2023 15:29:25 UTC – Details)
This diamond hole saw set comes with 15 drill bits of different sizes. The opening diameters are 6/8/10/12/14/16/18/20/22/25/28/30 / 35/40/50mm, which can meet most of the opening needs.
Diamond hole saws are suitable for drilling hard materials such as tiles, ceramics or glass, hard pvc. Drill hard materials with water at low speed without impact.
how to use?
a- Use a pen to draw the desired hole, holding the drill in place until it marks the initial mark.
b- Use an adjustable speed drill or screwdriver, set to 1 or any case below 400 rpm. It has to be turned very slowly at the beginning, then tilted 45° (to prevent slipping), drilling slowly from one corner first.
c- Always turn the tool slowly, wait for the edge of the drill to form a C-shaped groove, then move the drill vertically.
d- Low speed and low pressure drilling, drilling is completed.
Note: The thickness of the drilling material is less than or equal to about 3CM
The drilling process must be continuously cooled with water!
If possible, please operate under the water pipe, the cooling effect is better.
a- You can build a mini dam around it.
b- You can choose to spray water on the tip.
c- Or you can use running water to cool the tip.
Can be used for perforating glass, ceramics, marble, granite, rigid PVC, etc.;Not for use on steel, wood, hard concrete.
Note: It is suitable for ordinary glass, but not for tempered glass.
Compatible and easy to use:
bench drillelectric screw driverElectric drill/hand drill
Applicable industry: suitable for processing glass, ceramics, marble, granite, rigid PVC, etc. for drilling
Suitable for use in drill hole on glass, marble, tile ,blocks jars, fiberglass porcelain tile ceramic, slate mable, granite light Stone etc. Will work with all electric drill and impact drill.
Side holes help to remove the waste material easily; And surface nickel plating, extend the service life, enhance the surface corrosion resistance.
Simple operation, start your hole diagonally, draw a round track and then keep the drill straight. In the process of opening the holes to continue adding water for cooling.
When cutting hard materials it is important to ensure the cutter is kept cool to avoid damage to the material being drilled and premature wear of the cutter; Water is required for lubrication when drilling, which can extend the life of the drill bit set.